Install and Run Cisco's AnyConnect client for VPN connectivity

This guide will assist with the installation of the Cisco AnyConnect VPN client for Windows (Vista, 7, and 8)

Installation

You need administrator level account access to install this software. When prompted with Windows UAC (User Access Control) you need to allow to install this software.
  1. Download the VPN installer from MIT's download page, Cisco AnyConnect VPN Client for Windows. Note: MIT certificates required.
  2. Find and double click the downloaded file named "anyconnect-win-3.1.XXXXXX.exe", where XXXXXX is the sub-version number of the installer.
  3. On the following screen titled "Welcome to the Cisco AnyConnect Secure Mobility Client Setup Wizard", click Next.
    Welcome Screen
  4. When presented with the software license agreement, click I accept on the slide-down menu and click Next.

    License Agreement
  5. Click Install when prompted (Note: the user must be an administrator of the machine to install).

    Ready to Install
  6. When installer begins installation you will see

    Status Bar

    followed by Windows UAC (User Access Control) dialog box (it could be hidden behind this dialog box). You need to click Yes in order to proceed.
     
  7. Click Finish when prompted to complete installation.

    Setup Complete Screen
  8. Cisco AnyConnect can be found in the Cisco folder located under All Programs in Windows Start menu.
  9. Run "Cisco AnyConnect Secure Mobility Client" and when prompted type vpn.mit.edu and click Connect.

    VPN
  10. Enter your MIT username and password then click the button labeled OK.

    Username and Password
  11. When prompted at the MIT's Virtual Private Network (VPN) screen click the button labeled Accept to connect to MIT's Virtual Private Network.

    Accept/Disconnect
  12. Upon successful connection, Cisco AnyConnect will minimize itself and you will see the AnyConnect logo with a small lock in task bar.

    Task Bar

No comments :